JBL P8662 6x8" Two-Way Power Series Speakers

One of the very latest from the JBL® Power Series® will change how you think and feel about music in your car. The advanced technology of the JBL® P8662 includes proprietary, patented Plus One® woofer cones and tweeters worthy of home theater systems. You get the full audio spectrum – from big, true lows to clear, taut highs. In your car. Really.

Plus One® woofer cone

The Plus One® Honeycomb-Laminate™ woofer cone is exceptionally stiff and lightweight, with up to 25 percent more active surface area than a standard one of the same size. With a long-excursion surround, it boosts bass output and efficiency by two to three decibels compared with others.

Home theater-quality tweeter

It’s not the miniature tweeters that most other manufacturers use, but a high-bandwidth, edge-driven textile-dome tweeter like those found in very high-end home audio loudspeakers. Crank it up. You get less distortion at even high volumes and superior integration with the midwoofer.

Unipivot™ rotating tweeter

Another JBL® feat of engineering: the tweeter is mounted on a 15-degree angle so you can rotate it nearly 360 degrees to aim it at the listening position for improved high-frequency response

Mount and listen however you like

The JBL® P8662 has tweeter-level control. Use the simple switch to set the tweeter output level to match your personal listening preference, or different mounting locations.

Great audio output and frequency response

You’ll have 75 watts RMS and 225 watts peak power handing. And push them to the limit. You’ll hear true JBL® sound, with nothing under- or over-emphasized. The P8662 has a frequency response of 40Hz to 23kHz.

Higher SPL than ever

In addition to better sound quality, the new, proprietary, JBL-patented woofer design offers far higher SPL (sound pressure level) and better suspension symmetry for lower distortion than the previous generation.

Higher efficiency than ever

These speakers make the best use of any amplifier by providing an optimum 2-ohm load. They use a lower-impedance voice coil than a typical speaker to extract the most power and performance possible from all amplifiers engineered to drive loads of 4 ohms or less.

Outboard crossover networks

Outboard crossovers are integrated into a harness connected to each speaker for easy installation. Oversized Direct-Connect terminals ensure perfect connectivity for bare speaker wires.

In the Box: (2) P8662 loudspeakers, speaker clips, (8) screws, owner's manual